logo_color_S165_2x_bg social_03

Since 1952

PHONE: (317) 898-0750  

Grinding and Polishing Machinery located in Indiana

header2
Watch Grinding & Polishing Videos Contact Wheels Idler Pulleys Instructions & Parts Lists 1418441391_settings-24-128

GRINDING AND POLISHING MACHINERY * 2801 TOBEY DRIVE INDIANAPOLIS, IN 46219

Copyright G&P Machinery* Website designed by NVS Design Inc.

Wolfhead & Vonnegut Sanding Heads

MODELS: B272-2 B272-3

B2572-2 B2572-3

B372-2 B372-3

SPECIFICATIONS – BASIC UNIT

Motor – 2 HP, 3450 RPM, 3 phase, 60 cycle, 230 volt, 460 volt, 575 volt, Nema Frame size 145T Rated for continuous service.

 

Push Button type OFF—ON switch. Overload protection enclosed.

Motor Pulley: 6” dia, x 3 ¼” face (2 degree crown).

Abrasive Belt Size: 2”, 2 1/2” or 3” wide x 72” long.

Width dependent on model .

Contact Wheel: 6” dia. x 2” face, 2 ½” face or 3” face. Serrated face.

 

Lubrication

All bearing (motor and contact wheel) are sealed for life type.

Two Alemite fittings … One on the swivel casting and one on the swing casting requires periodic lubrication with a good grade of grease as use dictates, or at least once every three months.

 

Adjustments

Belt tracking knob provides a threaded lateral pivoting adjustment of the spindle for centering or tracking the abrasive belt on the contact wheel.

 

Pivot Lock controls the pivot adjustment.

To move the contact wheel up or down. It

can be locked at any point in the arc of travel.

 

Swivel Lock controls the swivel adjustment

To tip the contact wheel radially to left or

right this too can be locked at any point.

 

Pivot Lock and swivel Lock may be used

independently … or in combination.

Belt Tensioning Lock is used to lock out

the belt tensioning spring action within

the tube when changing abrasive belts.

 

Be sure all guards are in place with the door closed when operating this

equipment, always wear eye protection. When using a swing grinder, the operator must have a clear level area on which to stand, and the operator’s hands should be kept on the handle bars of the grinder when operated as swing grinder. Failure to heed this warning may result in

serious injury.

Back

ABRASIVE BELT GRINDER OPERTING & MAINTENANCE INSTRUCTIONS

ABRASIVE BELT GRINDER PARTS LIST

MODELS: B272-2 B272-3

B2572-2 B2572-3

B372-2 B372-3

Screen Shot 2015-02-23 at 11.16.02 AM Screen Shot 2015-02-23 at 11.14.33 AM Abbrasive Belt Grinder Parts Graphic Back

Abrasive Belt Grinder:

Operating & Maintenance Instructions

made in USA

Additional Categories