PHONE: (317) 898-0750
GRINDING AND POLISHING MACHINERY * 2801 TOBEY DRIVE INDIANAPOLIS, IN 46219
Copyright G&P Machinery* Website designed by NVS Design Inc.
Model: ABS-HD Right Hand-Air Tensioned
Spring and air tension.
SPRING TENSIONED & AIR TENSIONED
Left hand with optional
angle mounting brackets
SERIES SBS (REPLACES RBS) SPRING TENSIONED
The SBS series of backstand idlers offer an economical method of tensioning and abrasive belt for manual grinding applications. Tension is provided by a torsion spring. The 6” dia. Pulley is machined from an aluminum casting, and rotates on sealed ball bearings. The arm and base of the backstand are made of cast iron
Model SBS-4 for belts of 4” width or less
Model SBS-6 for belts of 6” width or less
Angle Mounting Brackets
Shown on the front of this bulletin. When the backstand idler is to be at floor level, the
angle mounting brackets position it at an angle that simplifies mounting a guard.
Provides a mounting for backstand idler at approximately the same height as the
Provides the advantage of removing the tracking knob from the base of the backstand and
repositioning it at the front of the machine within easy reach of the operator.
SERIES ABS-HD AIR TENSIONED
The ABS-HD series is adequate for grinding applications where pressure assist units are used to apply grinding pressure. Tension is provided by a heavy duty air cylinder. The 9” dia. pulley is machined from an aluminum casting, & rotates
on sealed ball bearings. The base of the unit is a weldment.
Model ABS-HD-4 for belts of 4” width or less
Model ABS-HD-6 for belts of 6” width or less
Model: ABS-HD Left Hand-Air
Model: SBS-4 Right Hand – Spring
Models and specifications shown on other side
Drop in replacement for Spring
Tensioned Toro Backstand Idlers
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
Always wear eye protection when grinding • Be sure all guards are in place