logo_color_S165_2x_bg social_03

Since 1952

PHONE: (317) 898-0750  

Grinding and Polishing Machinery Maintenance in the United States

header2
Watch Grinding & Polishing Videos Contact Wheels Idler Pulleys Instructions & Parts Lists 1418441391_settings-24-128

GRINDING AND POLISHING MACHINERY * 2801 TOBEY DRIVE INDIANAPOLIS, IN 46219

Copyright G&P Machinery* Website designed by NVS Design Inc.

Wolfhead & Vonnegut Sanding Heads

OPERATING AND MAINTENANCE INSTRUCTIONS

FOR MODELS: B290-5, B390-5, B490-5

B290-7, B390-7, B490-7

 

SPECIFICATIONS - BASIC UNIT

Motor: 5 or 7 1/2 H.P., 3450 RPM, TEFC, 184T Frame. Rated for continuous service. Starter: IEC Magnetic Push Button with overload protection.

Motor Pully: 6” dia. x 4-1/4” width (2 degree crown).

Abrasive Belt Size: 2” - 3” or 4” wide x 90” long - Width dependent on model.

Abrasive Belt Speed: 5500 SFPM (7500 SFPM optional)

Contact Wheel: 8” dia. x2” face-3” face or 4” face-Serrated Face.

CAUTION

Be sure all guards are in place with the door closed when operating this equipment. Always wear eye protection. When using as a

swing grinder, the operator must have a clear level area on which to stand, and the operator’s hands should be kept on the handlebars of the grinder when operated as a swing grinder. Failure to heed this warning may result in

serious injury.

All ball bearings (motor and contact wheel) are

sealed-for-life.Two Alemite settings . . . one on the

swivel casting and one on the swing casting . . . require periodic lubrication with a good grade of grease as use dictates, or at least once every

three months.

Operating Maintenance 1 Operating Maintenance 2

LUBRICATION

ADJUSTMENTS

The belt tracking knob provides a threaded lateral pivoting adjustment of the contact wheel shaft for centering or tracking the abrasive belt on the contact wheel.

 

The pivot lock controls the pivot adjustment . . . to move the contact

wheel up or down. I t can be locked at any point in the arc of travel.

The swivel lock controls the swivel adjustment . . . to tip the contact

wheel radially to left or right. This too can be locked at any point.

The pivot lock and swivel lock can be used independently . . . . or in combination.

BELT TENSIONING

Tensioning of the abrasive belt is accomplished by the use of an air cylinder and hand valve. The amount of tensioning can be adjusted by increasing the amount of air pressure shown on the regulator gauge. The normal setting is around 30 psi.

 

To change the Contact Wheel Tire . . . remove the screws holding the outer ange, remove the ange, then remove the old tire and install the new tire. Be sure the rim of the new tire is on the pilot or shoulder of inside hub before replacing outer ange.

Screen Shot 2015-02-18 at 5.49.09 PM

PART LIST FOR

MODELS -- B290-5, B390-5, B490-5

B290-7, B390-7, B490-7

MODELS -- B290-5, B390-5, B490-5

B290-7, B390-7, B490-7

Screen Shot 2015-02-18 at 5.55.01 PM Back Back

Operating & Maintenance Instructions

made in USA

Additional Categories