logo_color_S165_2x_bg social_03

Since 1952

PHONE: (317) 898-0750  

Grinding and Polishing Machinery specializing in custom grinding and polishing machines

ABRASIVE LOADING

One filling of these models is called a LOADING. This consists of 3 assemblies… each of which has

4 abrasive strips fastened at one end by a cloth loop. See abrasive loading price sheet

 

With the nut and cap plate removed, install each assembly with the

loop over a pin and the abrasive strips projecting between 4 adjacent

brush holders (and brushes).With all 3 assemblies in place, the Head

should appear as in photo at left.

 

Following this, replace the cap plate and the nut, leaving the nut

loose until abrasive is wound in. Holding the back plate stationary,

grasp the outer edges of the cap plate and turn it in the direction that

the head will rotate when in operation. Turn until approximately ½”

of abrasive remains beyond the brush tips.

 

At this point, Tighten the nut…being sure that the locking

indentation in the cap plate falls between 2 of the brush holders. The

nut should be nger tight.

 

CAUTION: Always be sure the ends of all brush holders are INSIDE the

lip of the cap plate BEFORE Operating.

 

ADJUSTMENTS

When fresh abrasive is required, loosen the nut suciently for the locking indentation to clear

the brush holder. Turn the cap plate the opposite direction of that used to wind the abrasive in.

Moving the lock one space (between brush holders) is normally sucient to provide the needed

extension. Tighten the nut. When a tool is started, extension of abrasive will occur either from

centrifugal force…or as soon as work pressure is applied.

 

MOUNTING

These Heads can be mounted on air tools, Electronic tools, or exible shaft machine by means of

adaptors, BE SURE THAT TOOOL SPEED DOES NOT EXCEED MAXIMUM SAFE RPM LISTED.

These speeds, and the choice of adaptors oered, are listed on the reverse side. A minimum of ¾ HP is recommended for models having abrasive 2” or wider.

header2
Watch Grinding & Polishing Videos Contact Wheels Idler Pulleys Instructions & Parts Lists 1418441391_settings-24-128

GRINDING AND POLISHING MACHINERY * 2801 TOBEY DRIVE INDIANAPOLIS, IN 46219

Copyright G&P Machinery* Website designed by NVS Design Inc.

Wolfhead & Vonnegut Sanding Heads

SIXTY SERIES - 12 BRUSH - PORTABLE HEADS

Back Graph 1 for Sixty Series Graph 2 for Sixty Series

OPERATING SPEEDS

MOUNTING ADAPTORS

CHOICE OF 1 INCLUDED WITH HEAD

Back

Operating Instructions

made in USA

Additional Categories

Screen Shot 2016-08-17 at 1.37.37 PM Screen Shot 2016-08-17 at 1.38.01 PM
Download

1/2" -  3/8"