EPN SPINDLE STAND
2 H.P. 1200 or 1800 RPM.
(shown with pneumatic drum and Wolfhead)
G&P Model EPN Sander/Poisher
Occupying a minimum of floor space, this model offers an economical means of driving a variety of sanding and polishing wheels.
Powered with a 2 horsepower motor and equipped with 1-1/4” diameter spindles, the EPN can accommodate a pair of Brush-Backed Sanding Heads, a pair of pneumatic drums... or one of each. The spindle length is 11” from shoulder to tip, providing adequate length for 9” wide drums.
Exhaust Hoods
The exhaust hoods shown in the picture are for use with Brush-Backed Sanding Heads. Regardless of the wheel used, some type of guard must be installed, but because of the variety of wheel sizes, guards are frequently custom built.
model epn
SPECIFICATIONS
​
Motor, 2 HP totally enclosed,
208/220/440 volt, 3 phase, 60 cycle
Speed, 1200 or 1800 RPM
Electrical Controls - Manual Start - Stop, Push Button with overload protection. (Specify which voltage will be used.)
Base Dimension 20 x 20”
Total Spindle Length 35”
Spindle Height from Floor 39”
Spindle Diameter 1-1/4”
Spindle Length 11” from shoulder to tip
Specifications are subject to change without notice.
Sanding Wheels and Guards not included in basic price.
Never operate sanding equipment without proper guarding. Always wear eye protection.
