grinder Mounting options
Converts a lathe into O.D. polisher with Compact and Medium duty swingframe grinder and other special abrasive belt grinder mounting options
3 H.P. to 15 H.P. Standard, Please consult us for other Horsepower requirements.
Mounting grinder options
Standard Swingframe Grinders Lathe Mounted
Special Abrasive Belt machines For Robot End of
Arm Mounting
Special I.D. Grinders For Welding Manipulator Mounting
Pedistal Mounting Options
Trunnion Mounting with Air Assist Cylinder
Special Powered Carriage Mounting with Joystick Controls for Up/Down and Left/Right for O.D. Grinding
grinder Mounting options
The Compact Duty 72 Series
The Compact Duty 72 Series Grinders are equipped with a 2 or 3
horsepower motor 208-230-460 volt, 3 phase, 60 hertz motor. The
abrasive belt size is 2”, 2.5” or 3” wide x 72” long as indicated by the chart.
The Medium Duty 90 Series grinders are equipped with a 5 or 7.5
horsepower motor 208-230-460 volt, 3 phase, 60 hertz motor, the
abrasive belt size is 2”, 3” or 4” wide x 90” long as indicated by the chart.
Accessories:
As shown on the front side, these grinders can be converted from swing frame grinders to lathe grinders, pedestal grinders, and plate/weld grinders with the proper accessories. The third wheel attachment can be used as a contact wheel or slack of belt polisher. Consult factory for additional information.
Contact Wheels:
The proper contact wheel is an important factor in any grinding application:
* 90 durometer serrated face for rapid stock removal.
* 70 durometer serrated face for general purpose grinding.
* 50 durometer serrated face for moderate stock removal and polishing.
